DAT file into the same folder above and that one does not work either. In a previous post I requested another license file which I got "sw_license_email_4015076". But apparently the installed program is not recognizing this file as the license file. Nearly any desired counting option can be configured directly on the device using the function buttons.You for your post, I have downloaded Creo version 4.0 and have installed it, however when I open it I get a message " license request failure". I checked in C:\ProgramData\PTC\Licensing for the license file and it is there BE410708EDSTUDENTEDK12_license, this is the license the program loads up. The special advantage of the electronic position indicator lies in its programmability. The required energy is supplied by a lithium battery with a lifespan of 5 or 8 years that can be easily replaced. The measurement of the spindle rotations takes place directly, electronically and without contact. The protection class IP 65 or IP 67 of the housing permits use in wet areas, even in contact with direct streams of water. The electronic position indicators GN 9053 / GN 9054 are very similar to the mechanical position indicators GN 953 / GN 954 / GN 955 with regard to installation and external dimensions and can normally replace them. The foam rubber seal prevents the transmission of vibrations and also acts as a seal. Mounted in this way, the indicators will detect the rotary spindle movement and show the appropriate value on the display.īoth housing sections are ultrasonically welded, making the housing very tightly seated, stable and compact. Indicators are mounted directly onto the spindle via their hollow shaft, with the torque limiting pin, determining the location of the mounting site.
The power necessary for the display is supplied by a long-life battery. Electronic position indicators GN 9054 with LCD display are extremely versatile, with virtually every incremental measurement option selectable directly on the device via the operating buttons.
0 kommentar(er)
